3shape e1 scanner calibration 영어 번역 칼리브레이션 내용

3shape e1 scanner calibration

I am using a dental 3shape E1 scanner.

I'm using 1 as it doesn't seem to be much different from 3shape e4.

But the 3shape e4 would fit better, right?

The E1 scanner feels that if the temperature is too high, 

the accuracy of the scanner is considerably lower.

It's a scanner that pops up a model, and the scene  it is calibration now

I think it is good to make it less than 5 degrees.

If so, does the temperature rise even though the temperature remains still??

Can you see the temperature? It is about 5 degrees apart. 

Is there too much difference from the temperature during calibration?

I don't think so. The reason is usually if you do something else while scanning

You can see that the light on the scanner stays on.

At this time, you can see that fever occurs.

Is the dental scanner calibrated once a week?

dental scanners are on Mondays based on 7 days

It is better to do it on the Monday of that week, and do not make frequent corrections in the company.

In my opinion, scan and correct it the next day if the fit is not good or the result is not good.

This is the same for oral scanners. Since I'm usually busy in the doctor's office, I think there are many cases where files are not processed without correction.

So the accuracy is very low, and the results vary a lot depending on the operator.

관련글 보기

캐드캠밀링-아름5x300 가성비로 좋은 밀링기

치과cad/cam 신터링

Denatl.design 3shape hyperdent에 대한 기초 맛보기